Talk and ask questions about NetApp FAS and AFF series unified storage systems. Talk with other members how to optimize these powerful data storage systems.
Talk and ask questions about NetApp FAS and AFF series unified storage systems. Talk with other members how to optimize these powerful data storage systems.
Hello everyone, sorry to bother you. I have a FAS8040 storage device, and one of the controllers has a Primary firmware failure that requires repair. However, I do not have FAS8040 SP firmware and do not have permission to download it. I wonder if any friends can help share it. Any version that is the same or lower than 3.12 is acceptable. The English is too poor, the translation tool has been used to translate it. Thank you very much! SP fas8040-01*> sp status Firmware Version: 3.1.2 Mgmt MAC Address: 00:A0:98:9E:8C:9A Ethernet Link: Up, 100Mb, Full-Duplex, Auto-neg enabled,completed Using DHCP: no IPv4 configuration: IP Address: 172.16.14.66 Netmask: 255.255.255.0 Gateway: 172.16.14.1 IPv6 configuration: Disabled Running Backup Firmware SP fas8040-01*> version Booted backup firmware version 3.1.2 Primary firmware version 3.1.2 Backup firmware version 3.1.2 Running Backup Firmware
... View more
. Where is the disk ownership info saved? Is it save on the drives or in on the OnTap configuration? Typically we erase the drives in the expansion shelf using a 3rd party erasure program like Blancco or XErase and then run wipeconfig on the controllers. Is that good enough or will those drives retain the ownership info?????
... View more
I have some AFF800 with some X4013A that I pulled out and put in an expansion array and we have a NetApp NS224 with similar drives. We have to wipe them using one of our 3rd party erasure programs. One of the programs runs on Windows and the other program runs independently. I believe changed them back to unprotected using he boot menu option 9 and even tried some commands. I'm thinking the boot sectors might not be standard. Any other suggestions while I wait for the equipment to arrive so I can hands on would be greatly appreciated.
... View more
We are currently seeing an amber alert LED (!) on our NetApp V6290 system running in 7-Mode. The system is configured as an HA pair with multiple DS2246 shelves and SAS adapters. The system is functioning normally, but the warning LED remains active on one of the controllers. We've already checked system status, environment, and hardware, but have not yet identified the root cause of the alert. We are looking for suggestions on what to check next or how to clear the alert LED under 7-Mode. Any advice from the community would be greatly appreciated. Thanks in advance!
... View more
Hi,
I am new on netapp system, I am try to covert a volumen rw to a dataprotection type to used it as mirror of another volumen, but I don't know how do it or if it is posible.
and I have another question Whe you delete a snapmirror relationship, what means de option: " Ok Release the base Snapshot copies of the reationship on the source volume. If you do not select this option, you need to go to ONTAP CLI on the source side to release later"
Thanks in advance.
... View more
